- length : 3750 mm
- height : 2750 mm (by the request of the customer)
- width 2550 mm
- number of pallets : 8 Eur-pallets
- volume: approx. 22 m³
- total load capacity :
jis made of bent sections of 4 mm thickness, St. quality of 52.2, floor structure of height 203 or 180 mm, floor plate of anti-slip waterproof plywood of thickness 27 mm (24 mm). Clamping elements are made in special design, four pieces of support legs, rigid or telescopic, door pull-out ladder. Guide tunnel wide 600 mm is made of two closed profiles. Stop profile against damage during handling of the car is at the front face.
Body – trapezoid
side, front and roof panels are made of galvanized punched sheet of quality St. 37.2, rear port is formed by a double-winged doors from galvanized sheet or rolling doors. Protective profile with a height of about 250 mm is at the lower edge of the body. The frame of the body is made of bent sections with a thickness of 3 and 3.5 mm, quality St. 37.2, four ventilation holes in the side walls. Steel bumpers protecting the body from damage are at the bottom of the rear portal.
Body – smooth
Side and front panels are made of smooth cassettes of galvanized sheet quality St. 37.2, roof panels are made of galvanized punched sheet, rear port with double-wing smooth doors of galvanized sheets or rolling doors, protective profile of height 250 mm is at the lower edge of the body. The frame of the body is made of bent sections with a thickness of 3 and 3.5 mm, quality St. 37.2 four air vents in side walls. Steel bumpers protecting the body from damage are at the bottom of the rear portal.
Surface treatment and marketing description
- sandblasting to SA 2.5
- chemical degreasing and chemical pre-treatment against corrosion in immersion tube
- cathodic dip coating in light shade from the outside and the inside
- powder coating in RAL from the outside and the inside by the request of the customer
- labelling and warning labels under DIN 284, DIN 283
- marketing description according to proposal